SilverNuts@Bolts
09-18-2004, 10:56 PM
Hello,
I haven't seen any posts on CS, as of late.
Today, as I write. I'm making my first brew.
I'm making about 48 oz [approx 1.5 ltrs], using low voltage DC, of 9.6V and currently I'm "running" at 0.4mA. I noticed, the negative plate is turning black, so something is happening. I have a power bar with a build in timer, which I set for 6 hours. I don't have a ppm reader and I'm not sure, what is the crieteria to determine, that "it's ready"? I think, next time around, I'll make it at night to eliminate the "lighting affect" [also it's brewing on top of my bed, so there is no lying down].
Any other ideas?
Thanks
I haven't seen any posts on CS, as of late.
Today, as I write. I'm making my first brew.
I'm making about 48 oz [approx 1.5 ltrs], using low voltage DC, of 9.6V and currently I'm "running" at 0.4mA. I noticed, the negative plate is turning black, so something is happening. I have a power bar with a build in timer, which I set for 6 hours. I don't have a ppm reader and I'm not sure, what is the crieteria to determine, that "it's ready"? I think, next time around, I'll make it at night to eliminate the "lighting affect" [also it's brewing on top of my bed, so there is no lying down].
Any other ideas?
Thanks