Question on CS

[Silverity]

Hi,

I just purchased a small bottle of CS at 10ppm out of curiosity.

I plan to take 2 teaspoons a day, and apparently I should not use a metal spoon.

Should such a dosage be taken before or after a meal?

Thanks,

Silverity.

[CJul]

Hi,

I just purchased a small bottle of CS at 10ppm out of curiosity.

I plan to take 2 teaspoons a day, and apparently I should not use a metal spoon.

Should such a dosage be taken before or after a meal?

Thanks,

Silverity.


I've never seen CS on sale – where did you buy it?

[G-khan]

Hi,

I just purchased a small bottle of CS at 10ppm out of curiosity.

I plan to take 2 teaspoons a day, and apparently I should not use a metal spoon.

Should such a dosage be taken before or after a meal?

Thanks,

Silverity.That is too small of a dose to be considered theraputic... It will be helpful in the sense that our food contains less Silver in it than it did 100 years ago and it should inhance your imune system to a small degree as it will kill of some of the invaders..

I make my Silver mineral water at about 13 to 14 ppm and 2 oz a day should be effective to keep most of the bacteria and virus from invading you... If you already have a condition take 4 oz a day of 13 to 14 ppm

Most people who buy a bottle of Silver mineral water (I call it mineral water as it is a better description than colloidal) never take enough to get the benifits of this powerful germ, bacteria, virus, fungus fighter. I recommend to all to get a generator and the cost then is 75 cents a gallon and you can then afford to take the amount needed..

This is the generator I had my wife buy me last Xmax for a present....

http://wishgranted.com/Colloidal_Silver_Maker_777_AC.html

It turns off by itself when done and makes a very consistant brew of 13 to 14 ppm when I set it at 5.5 on the dial - I tested it with a meter.

When it is first finished brewing it is clear I filter it through 5 brown coffee filters - (brown because they do not have the chemicals - bleach in them) and has a tinge of yellow after it sits for a while. This way I know I am getting only the very tiny particles. Oh by the way this generator makes a close to 50/50 solution of ionic and actual Silver particles most generators make 90% ionic.... 10% silver..

My advice is buy a generator the one I got comes with the Silver and all you need is distilled water and a fruit jar with a 2 1/2 inch top.

Read this for some more info.....
http://wishgranted.com/Colloidal_Silver_Research.html

[Silverity]

Thanks,

Does it matter whether you take the 2 fluid oz dose before or after food?

I may also persuade my wife to buy me one for xmas! However, we work off different voltages in Britain, so I will have to look elsewhere.

Regards,

Silverity.

[Silverity]

I am based in Britain where such things are rarer. I got it at ebay:

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&rd=1&item=5532294066&ssPageName=STRK:MEWN:IT

It's pricey, but I wouldn't buy it long term. Click on his other items button to see another bottle for sale.

Regards,

Silverity.

[G-khan]

I am based in Britain where such things are rarer. I got it at ebay:

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&rd=1&item=5532294066&ssPageName=STRK:MEWN:IT

It's pricey, but I wouldn't buy it long term. Click on his other items button to see another bottle for sale.

Regards,

Silverity.
They do have a universal model that may work for you... It costs 50 bucks more ....

http://wishgranted.com/Colloidal_Silver_Generator.html

[PONCE]

G? you sound to me like an expert on this, tell me, I make my own magic water and make my hot tea and sometimes coffee with it and my question is, once I make it hot is it still effective or am I killing it by drinking it that way?

[G-khan]

G? you sound to me like an expert on this, tell me, I make my own magic water and make my hot tea and sometimes coffee with it and my question is, once I make it hot is it still effective or am I killing it by drinking it that way?
I claim to be no expert... I read all I can on it and try to take what makes sense and post that...

My guess is it will still be ok but you would need to boil it and then turn it in to a lab for testing to make sure...

I am assuming it would be ok ...

I add mine to my concentrated canned juices and that seems ok. Without testing all would be guess work my friend...

Sorry I know of no one who has tested heat...

[G-khan]

Ponce if you ever want to test your cs go here...

http://www.colloidalsciencelab.com/aboutAnalytical.htm

[Silverity]

Thanks.

So this is a constant current machine? You also say it produces 50/50 ions and true particles. Did you figure that yourself or did the manufacturer have an analysis done?

Regards,

Silverity.

[G-khan]

Manufacturer claims it to be 50/50 same guy who designed my generator designed Silver Gens machine also so very alike...

[Silverity]

Sounds a good product, so when one states 15ppm (for example), that refers solely to the true non-ionic particles?

Thanks,

Silverity.

[gpond]

G-khan,

Sometimes my generator fails to shut itself off. Does yours ever do that?

I set at 5.5 the other day and left it overnight. It was still running in the morning so I just left it. Came home from work and was still running, so I knew something was up. If I turned the dial down a little it stopped.

I guess I will have to watch it and test it myself by adjusting the knob down towards 5 to see if it is "ready". Just wondering if you have seen this behavior?

Thx,
gpond

[SilverNuts@Bolts]

Exactly the same thing is going on with my generator. It's my first try, it's been running about 24 hours, not turning off till I move the handle to about 2.5. I'm thinking, maybe I have to much water in it [about 2 quarts]. The other question I would have is: do you use the air pump, for larger amounts of water? I'm thinking of trying that out, next time around. :banghead:

[G-khan]

Exactly the same thing is going on with my generator. It's my first try, it's been running about 24 hours, not turning off till I move the handle to about 2.5. I'm thinking, maybe I have to much water in it [about 2 quarts]. The other question I would have is: do you use the air pump, for larger amounts of water? I'm thinking of trying that out, next time around. :banghead:
If you use larger amounts of water move the electrodes closer... 1 1/2 to 2 inches a quart jar 2 1/2

Water temp plays a big part......

This has never happened to me I set it at 5.5 and it takes 4 to 6 hours to finish. I do leave about an inch of my previous batch in the jar as a primer...

[gpond]

My experience: using even a few "squirts" of CS as a primer greatly shortens the time to completion. Also, as G-khan said, the room temperature has a large impact on the length of time. The colder it is, the longer it takes. Lately I have not been having this problem. Mine is completing quickly and shutting itself off properly. However, if the generator has run for a reasonable amount of time, say 6 to 8 hours, I will move the knob from the 5.5 (where I have it set) downwards slightly to see if it cuts off. If it cuts off when I move the knob slightly to the left (downward) then I know it is done, or so close to being done that it doesn't make any difference. The manual that came with mine said this can happen. Anyway, the last two times, my CS generator cut off itself. The time before that I moved the knob to the left a little and it cut off, so I figured close enough. Again, just my experience.

[G-khan]

One other thing I bought the 8 inch strips of Silver - they are longer so in large batches my setup will be done quicker than the standard 6 1/2 inch strips. More surface area you have the faster it will put Silver into the water..

I use prego jars about 48 ounces - I got them at Sam's Club and I think this is about the only place you can get that large prego. The mouth of the jar is perfect and so is the debth for my longer electrodes... If you go to Sam's you may want to get one as they work very well even with the shorter strips of Silver...... and you get nice big batches...

[SilverNuts@Bolts]

I moved the knob again [few hours later], now the green light goes off at the "3" setting. Maybe by tommorow morning, it will be ready?
Thanks, for all the help. Nobody mentioned, if they use the air pump?

[G-khan]

I moved the knob again [few hours later], now the green light goes off at the "3" setting. Maybe by tommorow morning, it will be ready?
Thanks, for all the help. Nobody mentioned, if they use the air pump?
No I do not use it and you should not need one. My guess is water temp or you are not cleaning off your electrodes well enough.. You might want to pull them out now and wipe them off and stick them back in..... are they getting black?

[SilverNuts@Bolts]

It's 36 hours later now, the green turns off at "4". Cleaned the electrodes about 4 times, they are black every time. I had the water in the microwave for 1 min, prior to use. Next time, I'll warm it longer. Thanks G, for all the help.

[SilverNuts@Bolts]

After making a few "brews", with my new generator, my conclusion is, it is not meant for larger amounts of water. It works great, with about 1 Quart, 2 is to much, since after almost 2 days, it still does not reach the 5.5 dial. Better [and faster], to use less water. At 5.5, the brew is not clear water, it has a distinct golden color

[gpond]

After making a few "brews", with my new generator, my conclusion is, it is not meant for larger amounts of water. It works great, with about 1 Quart, 2 is to much, since after almost 2 days, it still does not reach the 5.5 dial. Better [and faster], to use less water. At 5.5, the brew is not clear water, it has a distinct golden colorI always make one quart in mine. I don't remember if this has been mentioned in this thread, but just in case this helps, I always make it in a very dark room. Also, I think my instructions mentioned to stay away from any large electrical field, such as close proximity to an electric motor, or such as that. SilverNuts@Bolts, I hope you get your problem figured out.

[gpond]

I reread your post. I see that it is working properly for one quart. Good! That is all I have tried to make, so far. If I make a quart a day I build up a stock fairly quickly. I, too, get a blackening effect on the silver strips which I clean off with an abrasive scrubber pad, and paper towels.

I really do love my "product" and use it everyday. I drink it occasionally, but mostly use eye-dropper and apply to ears, nose (snort), on my scalp, and rub excess from my scalp onto my face. Not bad for the complexion. Any fungal activity such as athletes foot or jock itch is a prime candidate. This stuff knocks it out! Just blabbering on...

[gpond]

Of course I usually don't get jock itch on my face! Unfortunate choice of words there! Ahem...

[gpond]

Some days I can't rub two words together.

[G-khan]

Some days I can't rub two words together.
I better just keep quite on this one..........:hahaha:

[G-khan]

Yea It could lead us astray.
I know we both want to go there ...............:cool2:

[SilverNuts@Bolts]

This post is starting to go in an unexpected direction.
Thanks G-pond for your help.

[SilverNuts@Bolts]

Forgot to mention. that I use the brew in my himidifier. The fine mist that it gives out uses a lot of water, I can't keep up.
Still using it on my hair, as an experment.

[gpond]

I use a very small amount in my humidifier to keep the filters fresh, but that takes very little. I don't see the point in filling the humidifier with 100% CS because I don't think very much Silver ever makes it out of my humidifier. Mine uses a wicking filter that a fan blows through to evaporate water into the room. I don't know much about other types.